We provide Tender Bidding Support for Supply of Ferritic Steel Coil 1.25X1250mm., As Per Drawing: Rdso Spec No.C-K201, Grade X2crni12 409M Table 1 & 2, Heat Treatment Condition 2B As Per Table-5, Coil Id 450-650, Od 1000-1300Mm, Coil Weight 5-10 Tonnes., Packing Instruction: Stainless Steel Austenitic & Ferritic Steel Coils Etc.: The Coil Shall Be Protected In Reasonably Good Condition To Withstand Normal Handling Hazard During Transit With The Following Provisions As The Barest Minimum: I Coil Should Be Wrapped With A Layer Of Water Proof Paper Throughout The Whole Length. Ii Coil Should Be Wrapped With A Layer Of Biodegradable Sheet. Iii Outer & Inner Of Coil Should Be Wrapped With Gi Sheet. Iv Side Of The Coil Should Be Covered With Card Board Sheet. V After This Whole Coil Should Be Wrapped With Biodegradable Plastic Sheet Of Suitable Thickness. Vi The Inner Edge Of The Coil Should Be Protected By Gi Ring, Followed By Another Iron Ring. Vii Outer Edge Of The Coil Should Be Wrapped With Gi Ring. Viii Coil Should Be Securely Strapped With Minimum 5 Steel Bands Through The Eyes Of The Coil And Minimum 3 Steel Bands On The Circumference Of The Eye. Ix Whole Coil Should Be Mounted On Wooden Blocks For Easy Lifting/Stacking. Ferritic Steel Sheet 10X1250x3000mm., As Per Drawing: Rdso Spec No.C-K201grade X2crni12 409M., Packing Instruction: As Per Standard Packing. It Should Be Ensured That Item Should Not Rub During Transportation. The Item Should Be Packed With Adequate Strength. Transit Damage, If Any, Shall Be At The Cost Of Supplier.