Analog Drive Tenders

(Select any tender from the list to send an email)
Ref. No #25595012 State Government Live   GeM Tender

Supply of Electrical Lab Equipment, Electrical Safety And Earthing Trainer, Digital Earth Resistance Tester With Testing Kit And Cable, Digital Insulation Tester Or Megger, Industrial Automation Plc Trainer, Three Phase Vfd , Soft Starter For Induction Motor, Resistive Load Bank, Electric Panel Mount Solid State Relay, Rlc Linear Variable Load Bank Three Phase, Motor Fault Simulator, Arduino Mega Kit With All Basic Sensor, Three Phase Induction Motor With Control Panel., Regulated Dc Power Supply, Semi-Automatic Motor Coil Winding Machine, Digital Storage Oscilloscope, Bench-Type Digital Multimeter- 4.5 Digits, Digital Handheld Lcr Meter For Component Testing, Basic Electricity Trainer Board For Basic Electricity Experiments., Three Phase Elecrtlcal Of Voltage And Current And Energy And Power Measrement Panel With Ct Or Pt Applications., Lcd Type Digital Watt Meter, Smart Energy Meter With Wi Fi Feature, Digital Ac And Dc Clamp Meter Upto 400A With Resistance, Frequency And Temperature, Fully Protected, Pmmc, Pmmi, Electrodynamometer Type Instruments Panel For Demonstration Model, Experimental Trainer Kit To Measure The Power, Power Factor In A Single-Phase Circuit, Using Wattmeter And Power Factor Meter And Verify Results With Calculations., Training Panel To Study Power Measurement In Three Phase By Two Wattmeter, Digital Portable Three Phase Power Quality Analyzer With 6000A Current Probe, 6 In 1 Ac Digital Meter, Single Phase Energy Meter Calibration Trainer, Single Phase And Three Phase Transformer Experimental Setup With Panel, Three Phase Transformer Experimental Setup With Panel, Dc Shunt Motor With Complete Control Panel And Loading Arrangement ., Dc Series Motorwith Complete Control Panel And Loading Arrangement ., Three Phase Auto Transformer

Location
Delhi
Due Date
13 Oct, 2022
Amount
41.31 Lacs
Ref. No #25582942 State Government Live   GeM Tender

Supply of Electrician Trade Tools Equipment - Electrician Screw r Thin Stem Insulated Handle 4 Mm X 100 Mm, Electrician Screw r Thin Stem Insulated Handle 4 Mm X 250 Mm, Punch Centre 150 Mm X 9 Mm Dia, - Knurled Body, Knife Double Bladed Electrician 100 Mm, Mallet Hard Wood 0.50 Kg, Hacksaw Frame Fixed Type 150 Mm, Limit Switch, Liver Operated 2A 500V, 2-Contacts, Cut Out Relays 16A, 440V, Reverse Current Relays 16A, 440V, Over Load Relays 16A, 440V, Under Voltage Relays 360V-440V, Insulator Pin Type Including Hardware Fitting, Insulator Shackle Types Including Hardware Fitting, Insulator Egg Type Including Hardware Fitting, Insulator Suspension Type Including Hardware Fitting, Load Bank Lamp Or Heater Type, 6 Kw 3 Ph, Brake Test Arrangement With Two Spring Balance 0 To 25 Kg, Thermometer Digital 0 C - 150 C, Fuse Rewire Type, Rheostat 0-25 Ohms 2 Amp, Rheostat 0- 300 Ohms 2 Amp, Rheostat 0-1 Ohms 10 Amp, Rheostat 0-10 Ohms 5 Amp, Low-Pressure Sodium Lamp, Plug Socket, Piano Switch, Lamp Holder, 230 V, 5 A, Bus Bar With Brackets 1 Mtr, Rubber Mat 60 X 120 X 2.5 Cm Or 2Ft X 4Ft X 1Inch, Mini Voltmeter Centre Zero 100-0-100 Mv, Watt Meter 0-1.5- 3 Kw, Watt Meter Digital 1Kw, 230V Digital, Energy Meter 3 Ph 440 V, 15 A, 4 Wire, Three Phase Power Factor Meter Digital 20 Amp, 440 V, Megger -500 Volts Cum Continuity Tester Or Insulation Tester Type, Wheatstone Bridge Complete With Galvanometer And Battery, Ac Starter Resistance Type Starter-For A.C Motors Of 2 To 5 H.P., Direct On Line Starter-For A.C. Motors Of 2 To 5 H.P., Star Delta Strater Manual-For A.C Motors Of 2 To 5 H.P., Star Delta Strater Semi-Automatic-For A.C Motors Of 2 To 5 H.P., Star Delta Strater Automatic-For A.C Motors Of 2 To 5 H.P., Soldering Iron 120 Or 125 Watt 230V, Tempreture Controlled Soldering Iron-50W, 230 V, A.C.Ceiling Fan And Ac Table Fan 1200 Mm. Sweep Single Phase 68 W. 250 V, Motor Pump Electric 1 Hp, Emd Detail, Required, No, Epbg Detail, A. The Emd % Will Be Applicable For Each Schedule/Group Selected During Bid Creation., Splitting, Bid Splitting Not Applied., Mse Purchase Preference, Mii Purchase Preference, 1. Estimated Bid Value Indicated Above Is Being Declared Solely For The Purpose Of Guidance On Emd Amount And For Determining The Eligibility Criteria Related To Turn Over, Past Performance And Project / Past Experience Etc. This Has No Relevance Or Bearing On The Price To Be Quoted By The Bidders And Is Also Not Going To Have Any Impact On Bid Participation. Also This Is Not Going To Be Used As A Criteria In Determining Reasonableness Of Quoted Prices Which Would Be Determined By The Buyer Based On Its Own Assessment Of Reasonableness And

Location
Gujarat
Due Date
01 Oct, 2022
Amount
Refer Document